Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Alternative</strong> <strong>Reader</strong> <strong>Wiring</strong> <strong>Guide</strong><br />
11. Dorado <strong>Reader</strong>s<br />
Use the following diagrams to wire Single/Dual <strong>Reader</strong> Interface Modules and Dorado readers.<br />
11.1. Dorado <strong>Reader</strong> Model 644<br />
For the Dorado <strong>Reader</strong> 644, a 16-position rotary switch (Trim POT) is now used for reader configuration. It<br />
is located inside the housing on the circuit board. The LED control is standard single wire. The reader should<br />
be configured to setting 5 (ABA cards, all bits, Wiegand).<br />
For Radionics hardware and cards, the reader mode is Mag with Wiegand output.<br />
(Not evaluated by UL)<br />
11.1.1 <strong>Wiring</strong> the BAS-1300<br />
TYPICAL SOFTWARE SETTINGS<br />
1. <strong>Reader</strong> Type = All other readers<br />
Black<br />
Brown<br />
Yellow<br />
White<br />
Green<br />
Red<br />
GND<br />
BZR<br />
LED<br />
CLK/D1<br />
DAT/D0<br />
+12V<br />
TR+<br />
Dorado <strong>Reader</strong><br />
Model 644<br />
TR-<br />
SG<br />
Single <strong>Reader</strong> Interface Module<br />
GND<br />
VDC 5 VDC<br />
Power Supply<br />
revision 7 — 45