Alternative Reader Wiring Guide - Best Access Systems

Nedap Readers
a. for the ASCII Setup:
b. Set the communication properties:
– BPS: 9600
– Data bits: 7
– Parity: Even
– Stop bits: 1
– Flow control: None
3. Check the current settings for the inter ID delay by typing in QC5 (must be in caps) followed by
.
4. Change the settings by typing SC532. Press . The screen should return SC532.
5. Once again, you can check these settings by typing in QC5 followed by to make sure the
parameters were accepted.
Any error will return a question mark (?).
112 — revision 7