Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Alternative Reader Wiring Guide - Best Access Systems
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Infographics <strong>Reader</strong>s<br />
16.1.2 <strong>Wiring</strong> the BAS-1320<br />
Infographics<br />
<strong>Reader</strong> OTD-60<br />
TYPICAL SOFTWARE SETTINGS<br />
1. <strong>Reader</strong> Type = All other readers<br />
2. Jumper J4 must be set to 5 VDC<br />
3. 2-wire LED control<br />
5V Voltage Jumper<br />
Settings, See manual<br />
for volt and current<br />
recommendations.<br />
1. Grey - 0 Volts<br />
2. Brown - <strong>Reader</strong> Clock<br />
3. Yellow - <strong>Reader</strong> Data<br />
Dual <strong>Reader</strong> Interface Module<br />
4. Green - +5 Volts<br />
VO<br />
5V+<br />
5. Red - Green LED<br />
LED<br />
6. Black - Yellow LED (not used)<br />
READER 1<br />
BZR<br />
D1/CLK<br />
7. Orange - Red LED<br />
8. Blue - Frame Ground<br />
D0/DATA<br />
GND<br />
VO<br />
EARTH GROUND<br />
LED<br />
READER 2<br />
BZR<br />
D1/CLK<br />
D0/DATA<br />
GND<br />
80 — revision 7