Conceptual Master Plan - Emeryville Center of Community Life

CONCEPTUAL DESIGN January 9, 2009
Emeryville Center of Community Life
4. Exposed exterior sealant to be Tremco “Dymeric” polyurethane sealant, with color to
be compatible with primary adjacent finish color.
4. Provide closed cell, bead or rod-shaped polyethylene foam backer rod where needed.
5. All sealants must meet LEED requirements for low VOC.
DIVISION 08000
Section 08110: Steel Doors and Frames
1. All fabrications to comply with HMMA standard 861 for minimum materials and
construction requirements
2. Provide hollow metal doors, 1-3/4” thick, 16-gauge face sheets. Refer to door
schedule for hardware and accessories. Shop prime all doors to receive final painted
coat in the field.
3. Provide hollow metal doors at all exterior doors except at aluminum storefronts as
shown on the exterior elevations. At interior, provide hollow metal doors at gym
storage, mechanical and electrical rooms only.
a. Exterior frames to be 14 ga., fully welded, galvanized and shop primed. Finish
paint color to match aluminum storefront system.
b. Interior frames to be 16 ga., fully welded and shop primed. Final paint colors to
be selected.
c. Hollow metal frames should have a 1/2” return.
d. Provide three wall anchors per jamb at hinge and strike levels plus floor anchors.
Provide temporary spreaders for all frames.
e. Provide Weather-stripping at all exterior doors.
Section 08210: Wood Doors
1. Flush doors shall be manufactured in accordance with the NWMA industry standards.
Manufacturer to be Weyerhauser or equal.
2. Wood doors shall be warranted against defects such as warpage in excess of 1/8” in 8
ft. Interior doors shall have warranty for life of the original installation.
3. Wood face veneer to be stain grade, species to match interior hardwood veneer and
trim, quarter sliced. Particleboard or mineral core, refer to door schedule for fire rating
requirements and locations.
Outline Specifications- 42