Volume 2 - Atomic Energy Regulatory Board

- Shield material, density, and quality control
measures followed during shield construction
- Maximum and minimum shield thickness, roof
thickness
- Drawings and layout of the device location
installed
- Dose rate profiles anticipated at various locations:
(Maximum and minimum values). Indicate them
on a sketch of the facility - control room, roof,
access doors, openings and where personnel are
expected to be stationed for work or otherwise.
- Radiation shielding evaluation including sky shine
- Maximum dose rate anticipated
Locations : (indicate also in a sketch)
11. Documentation Details of Auxiliary Services
(a)
(b)
(c)
(d)
(e)
(f)
(g)
(h)
(i)
Electrical power and power supply systems (including emergency
power supply), major electrical equipment, illumination, lift, hoist,
cranes etc.
Air conditioning and ventilation system (including treatment of
noxious gases produced, if any)
Cooling water supply system
Compressed air system
Communication system
Target gas handling system - system description, characteristics of
the gas (properties, specifications, purification etc.)
Laboratory, workshops, stores, etc.
Other services (please specify)
Controls of various subsystems, description, operation etc.
12. List of Potential Hazards and Safety Measures to be Taken
(a)
(b)
(c)
During precommissioning trials of all systems and subsystems
During commissioning
During operation and maintenance
13. Safety Features Including Hazard Evaluation
(a)
Design safety of buildings and equipment
183