2012 Ocean Ranger Guidebook Revision 3-7-12 - Alaska ...
2012 Ocean Ranger Guidebook Revision 3-7-12 - Alaska ...
2012 Ocean Ranger Guidebook Revision 3-7-12 - Alaska ...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>20<strong>12</strong></strong> <strong>Ocean</strong> <strong>Ranger</strong> <strong>Guidebook</strong> 3-7-<strong>12</strong><br />
chlorination and, if necessary, other treatment of the water shall be provided to maintain the residual<br />
chlorine in the pool water at not less than 0.4 part per million and the pH (a measure of the hydrogen<br />
ion concentration) not less than 7.0.<br />
(c) Flowing-through types of salt water pools shall be so operated that complete circulation and<br />
replacement of the water in the pool will be effected every 6 hours or less. The water delivery pipe to<br />
the pool shall be independent of all other pipes and shall originate at a point where maximum flushing<br />
of the pump and pipe line is effected after leaving polluted waters.<br />
Job Aid Item: 6.3.b<br />
Text: Free residual halogen of > 0.4 mg/ L (ppm) and pH not less than 7.0 is maintained in re-circulated<br />
swimming pools. (21 CFR <strong>12</strong>50.89 (b))<br />
Background: Pools must have a level of halogens<br />
to disinfect to reduce the likelihood of spread of<br />
diseases. pH must be maintained because low pH<br />
can interfere with the effectiveness of the<br />
halogen, and cause irritation for swimmers. pH<br />
should be in 1 7.0 to 7.6 range. Halogens should<br />
be in a range of 1 to 3 mg/L, but the regulation is<br />
only for at least 0.4 mg/L. A cruise ship should be<br />
recording these levels for the CDC.<br />
What to check for: Check that halogen and pH<br />
are measured and are greater than 0.4 mg/L of<br />
halogen (chlorine or bromine) and pH is at least<br />
7.0.<br />
Citation: See item 6.3.a<br />
Job Aid Item: 6.3.c<br />
Text: Halogen test is provided and used. (21 CFR <strong>12</strong>50.89 (b))<br />
Background: If they are maintaining residual halogen levels then they must be testing for them.<br />
What to check for: If halogen levels are maintained as in item 6.3.b check that a halogen test is<br />
provided. This could be a chlorine test kit, bromine test kit, or meters.<br />
Citations: See 6.3.a<br />
Figure 5- Water metering<br />
Job Aid Item: 6.3.d<br />
Text: Pool / spa water is handled / sampled IAW (VGP 5.1.1.2 and 5.1.2.3)<br />
Background: Pool and spa water must be dechlorinated and debrominated inside 3nm if discharged.<br />
Substances like chlorine used to disinfect pools will have a negative impact on marine life. This is<br />
particularly true if a fecal or vomit incident has been properly treated with high levels of halogens. This<br />
“superchlorinated” water would be well over water quality standards. Another reason to check this item<br />
is that ADEC has observed pool and spa water with high chlorine levels have damaged wastewater<br />
treatment equipment and upset biological treatment of wastewater.<br />
185