IP 55 Modular Cabinets

TIP: Internal door section
This section is attached on the inside of the door, directly to the
tubular reinforcement frame. It is used to attach cable raceways
directly to the
door of the cabinet and
permits the creation of
a continuous attachment
support in batteries
of cabinets.
See fig. 134.2 for application.
Dimensions in mm
A
Fig. 134.2
LIP - INNER DOOR CONSOLE WITH SUPPORT JACKS
CROSSPIECES AND ACCESSORIES
TIP, LIP - INTERNAL DOOR SHELF
17 TIP
4,25 ø bores
26 mm distance
Fig. 134.1
CODE
Nominal width
of door
I
TIP Section - INTERNAL DOOR SECTION: CODES AND DIMENSIONS
Characteristic Dimensions
A
I
TIP400 400 280 260
TIP500 500 380 360
TIP600 600 480 460
TIP700 700 580 560
TIP800 800 680 660
TIP900 900 780 760
TIPA00 1000 880 860
Dimensions in mm
This accessory is attached to the inner doorframe, as indicated in figure 134.3, with
two corner brackets, a staff and sliding and positioning jack. When it is not in use it
can be folded parallel to the door, without occupying space inside the cabinet. It is useful
for keyboards and documents.
The right and left groups of the support jack for the console shelf have a separate
code, which is indicated in the table that includes the entire assembly kit. The maximum
load that can be supported by the shelf is approximately 80 N.
LIP - INNER DOOR CONSOLE: CODES AND DIMENSIONS
CODE
Width of
cabinet
W
LIP500 500 430
LIP600 600 530
LIP700 700 630
LIP800 800 730
LIP/S Left and Right jack couples
Characteristic Dimensions
300
W
A
Fig. 134.3
BOZZA DI STAMPA
LIP/S
29
134
21 CATALOGUE