IP 55 Modular Cabinets

KCR090 - CONSOLE JACK KIT
This kit is applicable on consoles as a shelf support. It is always used in
pairs and is applied to the lateral vertical struts of the shelf support.
Corner (1) is attached to the inner part of the shelf, while corner (2) with
the sliding slot is attached to the lateral vertical struts of the console and
the shaft (3) acts as a sliding connection between the two corners. (See
Fig 136.1)
ACCESSORIES - KCR090: CONSOLE JACK,
BC0170: ANTI-CLOSURE BLOCK
1
KCR090
CODE
Characteristic Dimensions
Sliding slot length
KCR090 90
Dimensions in mm
BCO170 - MECHANICAL ANTI-CLOSURE DOOR BLOCKAGE KIT
3
Fig. 136.1
This device, which can be applied to AX and AZ series cabinets, permits closure of the
door only if the principle door has been chosen.
Obviously the two doors must be side by side, which is a typical arrangement for batteries
of cabinets. It is important and necessary to specify which door is considered the
principle one, whether left or right. (See Fig 136.3)
Fig. 136.3
Doors side by side
Vertical struts of
cabinets joined in
batteries
Setting of the
lever on reinforcement
tubes
BOZZA DI STAMPA
CODE
Supply characteristics
2
BCO170
Fig. 136.2
Make up of anti-closure door blockage kit
. BCO170 left or right;
. 4 ea. Cage nuts;
. 4 ea. M6 TEFR screws.
BCO170D
BCO170D/M
BCO170S
BCO170S/M
Kit dismounted right
Kit assembled right
Kit dismounted left
Kit assembled left
21 CATALOGUE
136