IP 55 Modular Cabinets

FUP - Front plate for AX, AZ and AF cabinets
Plate connection strut
When cabinets are joined with the front plate a free space
of about 110 mm is created between the plates, where the
cabinets are joined.
A plate connection strut has been designed in 2 mm thick
galvanised sheet steel, which is hooked to the borders of the
plate and successively attached with screws, so that a flat
and continuous joint is created. In general this space becomes
useful in placing cable raceways for the wiring, thereby
avoiding the use of space in the plates; for this reason the
connection strut has a series of bores where it is possible
to fix the raceways with self-threading screws.
PLATE CONNECTION KIT (FUP)
1 ea FUP (C);
6 ea. M8x16 TE F.R. screws (B);
6 ea M8 threaded inserts (A).
Fig. 28.1
H
CODE
A
C
ASSEMBLY INSTRUCTIONS
Nominal Dimensions
Fig. 28.2
a) Mount the plates so that they are aligned (at the same
depth);
b) Partially tighten the screws (B) on the threaded inserts (A)
on the side of the plates;
c) Insert the FUP plate connection strut (c), hooking it from the
top towards the bottom of the screws (B);
d) Tighten the screws (B).
H
B
Characteristics
FUP168 1600 Assembly Kit
FUP188 1800 Assembly Kit
FUP208 2000 Assembly Kit
FUP228 2200 Assembly Kit
BOZZA DI STAMPA
28
21 CATALOGUE