IP 55 Modular Cabinets
IP 55 Modular Cabinets
IP 55 Modular Cabinets
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
AX – <strong>IP</strong> <strong>55</strong> MODULAR CABINETS<br />
AX series cabinets are produced on the same line as the AZ<br />
series and are oriented towards a market that is sensitive to<br />
the cost-effectiveness of products, but also pays attention to<br />
the quality and technical-operational features required by the<br />
norms in force.<br />
The structures of these cabinets are completely welded and<br />
built of top quality press-bent sheet metal, so that the roof and<br />
bottom of the cabinet form a solid body with the four vertical<br />
uprights, creating an extremely rigid frame.<br />
The structure lends itself to modular combination with other<br />
elements in an extremely simple manner, minimising assembly<br />
costs. The painting cycle is performed by automatic plants, following<br />
degreasing, phosphation with iron phosphates and several<br />
successive phases of rinsing.<br />
The following stage consists of kiln drying and painting in a<br />
completely automatic cabin.<br />
Thermal hardening epoxy polyester type powders are used for<br />
the painting. The totally automatic production cycle guarantees<br />
the utmost precision, homogeneity and constant quality over<br />
the long term. Thanks to the polyurethane foam gasket installed<br />
with an automatic continuous gluing system, the <strong>IP</strong> <strong>55</strong> level<br />
of protection has been declared and certified.<br />
Fig. 8.1<br />
COMPONENTS OF THE BASIC CABINET<br />
The bearing structure is produced from completely welded<br />
drawn and perforated galvanised sheet steel sections, which<br />
guarantee mechanical sturdiness and total protection against<br />
water and dust, thereby consenting the firm to obtain the <strong>IP</strong> <strong>55</strong><br />
level of protection.<br />
The rear panel is made from press-bent sheet steel with centring<br />
bores to facilitate attachment with 6/8 M6 screws and is<br />
equipped with a gasket around the border that adapts perfectly<br />
to the structure.<br />
The fixed bottom in press-bent sheet steel has bores for the<br />
passage of cables and is equipped with the relative covers.<br />
The interior equipment installation plate is in 25/10 thick galvanised<br />
sheet steel and has double reinforcement fins along the<br />
entire perimeter. On request cabinet is also equipped with slides<br />
and pins to facilitate ubsertion of plate.<br />
BOZZA DI STAMPA<br />
8<br />
21 CATALOGUE
Change language