WEIGH SCALE BLENDER® - Maguire Products

WEIGH SCALE BLENDER®
MAGUIRE PRODUCTS, INC.
Selecting the Correct Model
Controllers are programmed to control all sizes of Weigh Scale Blenders.
The MODEL number that your unit is set for will be displayed during the start up sequence
every time power is turned on.
The possible models are:
Blender Model Blender Display Code Batch Weight (Grams) Weigh Bin Dimensions Load Cell Rating
MB MB 400 5” x 5” x 5” High 1 @ 3Kg
140 / 140R 140 / 14R 1000 10” x 6” x 6” High 1 @ 3Kg
220 220 2000 10” x 10” x 7” High 2 @ 3 Kg
240 / 240R / 260 240/24R 2000 10” x 10” x 7” High 2 @ 3 Kg
420 420 4000 10” x 10” x 10” High 2 @ 10 Kg
440 / 440R / 460 440/44R 4000 10” x 10” x 10” High 2 @ 10 Kg
940 / 960 940 9000 16” x 16” x 12” High 2 @ 10 Kg
1840 / 1860 1840 18000 16” x 16” x 17” High 2 @ 20 Kg
“R” Models have 2 removable hoppers
The addition of feeders will change the last digit of the model number.
This digit can be ignored for selecting the correct Model.
400, 1000 and 2000 gram systems with 3 Kg load cells; weights are displayed in tenths of
grams (xxxx.x).
4000, 9000, and 18000 gram systems with 10 or 20 Kg load cells; weights are displayed in full
grams (xxxxx).
If your unit is NOT set correctly to match the hardware you have, you must change it. To do so:
Turn power on. From the NORMAL mode:
Model Setup Keypad Sequence:
Press
Display will say: (PASSWORD)
Press Display will say: (MODEL 220)
Or
Whatever model it is currently set for.
Press
Press
To scroll through all model sizes.
When the model you want is displayed, then:
Wait a few seconds.
Controller will reset and restart as the system you have selected.
When switching models, all parameter table information is lost and the new "default" information for this model is
loaded from ROM.
If you should be in any doubt as to which is the correct model you should select please stop and contact your local
Maguire representative who will inform you by return.
Edition: March 24, 2008 20