WEIGH SCALE BLENDER® - Maguire Products

WEIGH SCALE BLENDER®
MAGUIRE PRODUCTS, INC.
Materials Rate Calibration
YOU DO NOT HAVE TO DO THIS.
Software is set to expect STANDARD hardware. If a device meters at a much lower feed rate then expected, the software will
take 10 to 20 cycles to fully adjust. During this time cycles will take longer.
An example of this is a system using a 1/2" auger instead of 1".
If you don't mind letting the system SELF ADJUST, or your hardware is STANDARD, then:
PROCEED TO: ENTERING SETTINGS NEXT PAGE
To perform a RATE CALIBRATION:
Have the HOPPER LOADED with enough material to run for several cycles without running out.
Have the "OFF AT END OF CYCLE" and "PAUSE" switches DOWN.
Material Calibration Keypad Sequence:
Press
Display will say: (PASSWORD)
Press Display will say: (P x)
If you are calibrating an auger feeder, operate it briefly to ensure it is fully primed. To do so:
Press
Press
Press
or
Display will say: (OPERATE)
Run until Auger Feeder is dispensing
This will empty the Weigh Bin
Now you can CALIBRATE the material. To do so:
Press
Press
Display will say: (CALIBRATE)
Component #5 will calibrate itself.
Repeat this two key calibration routine for EACH material that you wish to calibrate. Only components that have a TYPE
selected (not "OFF") will operate.
Each time a dispense will occur, followed by weighing, followed by a dump to empty the weigh bin.
Press Display will say: ( x)
YOU ARE NOW READY FOR ACCURATE PRODUCTION BLENDING.
PROCEED TO: ENTERING SETTINGS NEXT PAGE
Edition: March 24, 2008 26