B-SX4T Series, B-SX5T Series External ... - Toshiba Tec Italia

6.3.29 SAVED DATA CALL COMMAND (For ATA Card) [ESC] XT
Function
Format
Term
Calls PC interface commands saved in the ATA card.
[ESC] XT; dddddddd, b, c, d [LF] [NUL]
dddddddd: Identifier for the file to be called from the ATA card
File name within 8 characters
b: Drive
1: Slot 1 on the PCMCIA board (Option)
2: Slot 2 on the PCMCIA board (Option)
c: Status response when the data is called up
0: No status response made
1: Status response made
d: Auto call at power on time
L: Auto call
M: No auto call
Notes (1) If the relevant save identifier is not found, an error will result.
(2) However, if no save number subject to auto call is found with the option for auto
call at power on time selected, the option for no auto call will be selected causing
no error.
(3) If a command error is found in the PC interface command in auto call at power on
time by the Saved Data Call Command, a command error will result. After an
error has occurred, the power must be turned off. The option for no auto call is
selected when the power is turned on again.
(4) The printer enters the online mode (label issue operation) when the Save Data
Call Command is sent after the Save Terminate Command.
Refer to
Examples
• Save Start Command ([ESC] XV)
• Save Terminate Command ([ESC] XP)
[ESC] XT; PC_SAVE, 1, 0, M [LF] [NUL]
[ESC] RC001; Sample [LF] [NUL]
[ESC] RC002; 100 [LF] [NUL]
[ESC] XS; I, 0002, 0002C3000 [LF] [NUL]
- 222 -