B-SX4T Series, B-SX5T Series External ... - Toshiba Tec Italia

5.2 LABEL ISSUE OPERATION
An example of the label issue operation is described below.
(1) Where the Saved Data Call Command is not used:
Power ON
Place paper
Label Size Set Command
[ESC] D:
Sets the label size.
Position Fine Adjust Command
Print Density Fine
Adjust Command
[ESC] AX: Adjusts the feed length, cut position, and
back feed length.
[ESC] AY: Adjusts the print density.
Feed Command
[ESC] T:
Feeds one sheet of paper and aligns it
with the first print position.
Image Buffer Clear Command
[ESC] C:
Clears the image buffer.
Line Format Command
Bit Map Font Format Command
Outline Font Format Command
Bar Code Format Command
[ESC] LC: Sets the line format and draws it.
[ESC] PC: Sets the bit map font format.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the bar code format.
Bit Map Font Data Command
Outline Font Data Command
Bar Code Data Command
Issue Command
[ESC] RC: Draws bit map font data.
[ESC] RV: Draws outline font data.
[ESC] RB: Draws bar code data.
[ESC] XS: Issues (prints) the label.
Yes
Yes
Yes
No
No
No
Power OFF
NOTES: (1) When placing new paper, the Label Size Set Command and the Feed Command must
always be sent. When using the same paper after the power is turned off and on, the
Label Size Set Command and the Feed Command may be omitted.
(2) After the power is turned off and on, the Bit Map Font Format Command, the Outline
Font Format Command, and the Bar Code Format Command should be sent as
occasion demands because they are not protected in memory.
- 32 -