B-SX4T Series, B-SX5T Series External ... - Toshiba Tec Italia

[Rectangle]
(1) Radius of rounded corners = 000 or parameter omitted
(X 1 ,Y 1 )
(X 2 ,Y 2 )
Line width
(X 2 ,Y 2 ) (X 1 ,Y 1 )
Line width
Line width
Line width
(2) Radius of rounded corners ≠ 000
(X 1 ,Y 1 )
Line width
Radius
Line width
(X 2 ,Y 2 )
Notes
(1) In line designation, a horizontal line, vertical line, or slant line A/B is drawn
according to the start and end point coordinates.
(2) The result is the same even if the start and end point coordinates are reversed.
(3) The start and end point coordinates must be set so that the result of line drawing
will be within the effective print area set by the Label Size Set Command
([ESC] D).
- 58 -