B-SX4T Series, B-SX5T Series External ... - Toshiba Tec Italia

9.1.2 DETAIL STATUS
LCD Message of
Upper Line
(English)
Printer Status
Detail Status
Auto Status
Transmission
Status
Request
Command
ON LINE The head was closed with the head open. 00 00
HEAD OPEN The head was opened in the online mode. 01 01
ON LINE
Operating (Analyzing command, drawing, printing, – 02
feeding)
PAUSE **** In a pause state – 04
ON LINE Waiting for stripping – 05
Display of error message A command error was found in analyzing the
06 06
(See NOTE 1.)
command.
COMMS ERROR A parity error or framing error occurred during
07 07
communication by RS-232C
PAPER JAM **** A paper jam occurred during a paper feed. 11 11
CUTTER ERROR**** An abnormal condition occurred at the cutter. 12 12
NO PAPER **** The label has run out. 13 13
NO RIBBON **** The ribbon has run out. 14 14
HEAD OPEN **** An attempt was made to feed or issue with the 15 15
head open (except the [FEED] key)
HEAD ERROR **** A broken dot error has occurred in the thermal 17 17
head.
EXCESS HEAD TEMP The thermal head temperature has become
18 18
excessively high.
RIBBON ERROR**** An abnormal condition occurred in the sensor for 21 21
determining the torque for the ribbon motor.
REWIND FULL **** An overflow error has occurred in the rewinder. 22 22
ON LINE Ribbon near end state (Online) – 27
PAUSE Ribbon near end state (In a pause state) – 28
ON LINE Ribbon near end state (Operating) – 29
ON LINE A label issue has been completed normally. 40 –
ON LINE A feed has been completed normally. 41 –
ON LINE
A head broken dots check has been completed 00 –
normally.
SAVING #### &&&& In writable character or PC command save – 55
SAVING %%%%%%% mode
FLASH WRITE ERR. An error has occurred in writing data into memory 50 50
for storage.
FORMAT ERROR An erase error has occurred in formatting memory 51 51
for storage.
FLASH CARD FULL Saving failed because of the insufficient capacity of 54 54
memory for storage.
POWER FAILURE A momentary power interruption has occurred. – –
INITIALIZING... The memory card for storage is being initialized.
(Initialization is carried out for a max. of
approximately 15 seconds)
- 269 -