B-SX4T Series, B-SX5T Series External ... - Toshiba Tec Italia

(5) Head Open Error
If the head open sensor detects the open state in 5 mm continuously, an error will result.
If the head open sensor detects the open state when an issue, a feed, or an ejection is
attempted in a printer stop state, an error will result.
If the head-up sensor detects the head-up state in 5 mm continuously, an error will result.
If the head-up sensor detects the head-up state when an issue, a feed, or an ejection is
attempted in a printer stop state, an error will result.
However, the feeding by the [FEED] key on the printer and the issuing and feeding by the
expansion I/O are not included.
(6) Thermal Head Error
A broken dot error has occurred in the thermal head.
An error has occurred in the thermal head driver.
(7) Thermal Head Excessive Temperature
When the open-air temperature detection thermistor detects an excessively high temperature
(61 °C or more), an error will result.
When the thermal head temperature detection thermistor detects an excessively high
temperature (80 °C or more), an error will result.
When the heat sink sensor detects an excessively high temperature (91 °C or more), an error
will result.
(8) Ribbon Error
When the ribbon rewind motor sensor and ribbon back tension motor sensor do not perform
detection if twice the prescribed time has passed, an error will result.
• An abnormal condition has occurred in the sensor for determining the torque for the ribbon
motor.
• A ribbon jam has occurred.
• The ribbon has run out.
• The ribbon has not been installed.
(9) Rewinder Overflow
If the rewinder overflow sensor detects the overflow state in 5 mm continuously when the strip
function or the built-in rewinder is specified, an error will result.
If the overflow sensor detects an overflow state when an issue, a feed, or an ejection is
attempted in a printer stop state after the strip function or the built-in rewinder is specified, an
error will result.
* At the moment an error occurs, the printer shows the error message, makes a status response,
and then stops. Only the Status Request Command and the Reset Command can be
processed. Other commands are not processed. Restoration using the [RESTART] key is
possible except in the case of a thermal head excessive temperature error. (The printer
resumes printing a label at which the error had occurred.)
- 264 -