B-SX4T Series, B-SX5T Series External ... - Toshiba Tec Italia

(4) When the drawing data is changed per label issue during printing, the drawing
data field for the previous label is automatically cleared using the character string
number, then the next drawing data is printed. Therefore, the character string
number which differs according to the drawing fields should be designated.
Since the automatic field clear is not performed between the Clear Command
([ESC] C) and Issue Command ([ESC] XS), the fixed data may be drawn using the
same character string number. In this case, the Format Command and Data
Command should be sent alternately. (After the Issue Command is sent, the
fields with the same character string number are automatically cleared until the
Clear Command is sent.)
(5) When characters overlap due to the character-to-character space fine adjustment,
the outline font is not painted properly. Program the fine adjustment value so
that characters will not overlap. Also, when drawings such as lines or characters
are on the outline font drawing position, the outline font is not painted properly.
For font types A and B, the fine adjustment value should be set so that other
drawings do not overlap the area in which the outline font is to be drawn. For
font types E, F and G, the fine adjustment value should be set so that other
drawings do not overlap the area for the designated character width and height.
(6) The link field designation can be cleared by omitting the link field designation
using the same character string No. and reformatting data.
The link field designation can also be cleared by the Image Buffer Clear
Command.
(7) A print data string and the link field No. cannot be programmed at the same time.
Refer to
Outline Font Data Command ([ESC] RV)
Bit Map Font Format Command ([ESC] PC)
Bar Code Format Command ([ESC] XB)
- 91 -