B-SX4T Series, B-SX5T Series External ... - Toshiba Tec Italia

9.2 PARALLEL INTERFACE SIGNALS
9.2.1 COMPATIBILITY MODE
LCD Messages Printer Status Output Signal
of Upper Line (English) Busy Select nFault PError
ON LINE In the online mode L H H L
ON LINE In the online mode (communicating) L, H H H L
HEAD OPEN The head was opened in the online mode. H L L L
PAUSE **** In a pause state H L L L
ON LINE
Data was set from the host with the receive H H H L
buffer full.
ON LINE
After data was sent from the host with the L H H L
receive buffer full, some data is processed
and room becomes available.
ON LINE
Initialize process in execution (After the power H H H L
is turned on or the nInit signal is received)
Display of error command A command error has occurred in analyzing H L L L
the command.
PAPER JAM **** A paper jam occurred during a paper feed. H L L L
CUTTER ERROR**** An abnormal condition occurred at the cutter. H L L L
NO PAPER **** The label has run out. H L L H
NO RIBBON **** The ribbon has run out. H L L H
HEAD OPEN **** A feed or an issue was attempted with the H L L L
head opened. (except the [FEED] key)
HEAD ERROR **** A broken dot error has occurred in the thermal H L L L
head.
EXCESS HEAD TEMP The thermal head temperature has become H L L L
excessively high.
RIBBON ERROR**** An abnormal condition occurred in the sensor H L L L
for determining the torque for the ribbon
motor.
REWIND FULL **** An overflow error has occurred in the
H L L L
rewinder.
ON LINE Ribbon near end state (Online) L H H L
PAUSE Ribbon near end state (In a pause state) H L L L
ON LINE Ribbon near end state (Operating) L H H L
SAVING #### &&&& In writable character or PC command save L H H L
SAVING %%%%%%% mode
FLASH WRITE ERR. An error has occurred in writing data into H L L L
memory for storage.
FORMAT ERROR An erase error has occurred in formatting H L L L
memory for storage.
FLASH CARD FULL Saving failed because of the insufficient H L L L
capacity of memory for storage.
POWER FAILURE A momentary power interruption has occurred. H L L L
INITIALIZING... The memory card for storage is being
initialized. (Initialization is carried out for a
max. of approximately 15 seconds)
- 272 -