OVERHEAD LINE SPLICES

AUGUST 2012ANDERSON HUBBELL ® POWER SYSTEMS FARGO8® 11DOUBLE SUPPORT TIEFORMED WIREINSULATOR TIE “C-NECK” & “F-NECK”Double Support Ties are used in applications where the conductor is aligned to sit in the top groove of the insulator.This type of tie should not be used on line angles over 10 degrees with the insulator in a vertical orientation.Fargo LDID series formed wire double support ties are designed for use with ACSR, AAC, AAAC, Compacted ACSR,Compacted AAC & AWAC ® .C-Neck (2-1/4” neck diameter) & F-Neck (2-7/8” neck diameter) interchangeable headstyle insulators.Recommended for use with ANSIClass 55-2 Pin, 55-3 Pin, 55-4 Pin,55-5 Pin, 57-1 Post, 57-2 Post, &57-3 Post Insulators.Note:Consult factory for informationon other applications.Right hand lay standard.ALUMINUM ALLOYLDID0xxxLDID0xxxCATALOGNUMBERLDID0004LDID0001NOTES:NOMINAL CONDUCTOR SIZE DIAMETER RANGE PACKAGING PER BOXWT LBSAPPROX.APPLIEDACSR AAC AAAC MIN MAX UNITS (KG) LENGTH9/16” Minimum Groove Radius#4 (6/1)#4 (7/1)#2 (6/1)#2 (7/1)#1 (6/1)LDID0010 1/0 (6/1)LDID0020 2/0 (6/1)LDID0030 3/0 (6/1)LDID0040 4/0 (6/1)LDID0266266.8 (18/1)266.8 (26/7)#3 (7W) #4 (7W)#1 (7W)#1 (19W)1/0 (7W)1/0 (19W)2/0 (7W)2/0 (19W)3/0 (7W)3/0 (19W)4/0 (7W)4/0 (19W)266.8 (7W)266.8 (19W)266.8 (37W)#2 (7W)1/0 (7W)2/0 (7W)3/0 (7W)4/0 (7W)0.245(6.23)0.316(8.03)0.358(9.09)0.406(10.31)0.460(11.68)0.521(13.23)0.589(14.96)All dimensions: inches (mm) unless otherwise noted.AWAC is a registered trademark of Copperweld Co.0.277(7.05)0.357(9.08)0.405(10.30)0.459(11.66)0.520(13.21)0.588(14.95)0.665(16.89)5050505050505011(5.0)15(6.8)16(7.3)16(7.3)23(10.5)23(10.5)26(11.8)13(330)14(356)14(356)14(356)16(406)17(432)17(432)INSULATORIDENT. MARK“C”-BLACK &“F”-YELLOW“C”-BLACK &“F”-YELLOW“C”-BLACK &“F”-YELLOW“C”-BLACK &“F”-YELLOW“C”-BLACK &“F”-YELLOW“C”-BLACK &“F”-YELLOW“C”-BLACK &“F”-YELLOWCONDUCT.COLORCODEORANGEREDYELLOWBLUEORANGEREDPURPLE