Untitled - Franke

Securityware Products - Combi Units, Water Closets & Urinals
24 1/8"
(61cm)
15"
(38cm)
0311
14" (36cm)
11 1/2"
(29cm)
HDWC2414-RM shown
15"
(38cm)
24 1/8" (61cm)
1
2
HDWC2414-RM-
Heavy Duty Water Closet
Fixture Specification:
This Heavy Duty Water Closet (Toilet) is designed for areas requiring the
utmost in vandal resistance. The fixture is fabricated from heavy 14 gauge
type 304 18-10 stainless steel. The elongated bowl is drawn and seamlessly
welded and polished to a satin finish. The toilet seat is polished to a sanitary
mirror finish. Internal piping is also 14 gauge type 304 stainless steel.
Toilet
Elongated design blow out jet bowl. The toilet requires a minimum of 35 PSI
flow pressure. The toilet was tested and certified as a low water consumption
toilet using only 1.6 gpf (6 lpf). The trap will pass a 2 1/8" ball and has a
seal of 3.5" min. The waste outlet extends a minimum of 3" behind the
fixture and has a plain end OD of 2 3/8". Flush valve connection is 1 1/2”
FIPT rear spud.
The entire fixture is tested and certified to:
ASME A112.19.2-2008/CSA B45.1-08 standards.
Installation:
These fixtures are designed to be installed onto finished walls which are
serviceable from a pipe chase. Installation is achieved by threading (5) 1/2”
(13mm) diameter threaded anchor rods to the back of the fixture. The
anchor rods are then secured on the chase side of the wall by means of the
supplied nuts and washers. (Standard included hardware is for walls up to 8"
(20cm) thick).
For existing walls, an optional metal cutout template is available. For new
block (CMU) or poured concrete walls, an optional wall sleeve is available.
FIXTURE OVERVIEW:
1 1 1/2" FIPT Flush Connection
2 2 3/8" OD Plain End Waste Connection
143
GENERAL
INFORMATION
SINGLE COMPARTMENT
DROP-IN SINKS
CLASSROOM
SINKS
DOUBLE COMPARTMENT
DROP-IN SINKS
TRIPLE COMPARTMENT
DROP-IN SINKS
UNDERMOUNT
SINKS
VANITY
BASINS
DRAINBOARD
SINKS
SECURITYWARE