Untitled - Franke
Untitled - Franke
Untitled - Franke
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Securityware Products - Wash Basins & Sinks<br />
16"<br />
(40cm)<br />
18"<br />
(46cm)<br />
0311<br />
12"<br />
(30cm)<br />
28"<br />
(71cm)<br />
HDFSS1821-RM-SV shown<br />
21" (53cm)<br />
1<br />
19" (48cm)<br />
3"<br />
(8cm)<br />
2<br />
10"<br />
(25cm)<br />
4<br />
3<br />
HDFSS1821-RM- -<br />
Heavy Duty Floor Service Sink<br />
Fixture Specification:<br />
This Heavy Duty Floor Service Sink is designed for areas requiring the<br />
utmost in vandal resistance. The fixture is fabricated from heavy 14 gauge<br />
type 304 18-10 stainless steel. It is seamlessly welded and polished to a<br />
satin finish. Standard waste is a 2 3/8” OD Plain End Elbow.<br />
Compartment Size: (FB x LR x D):<br />
18" (46cm) x 21" (53cm) x 40" (102cm)<br />
Bowl Size: (FB x LR x D):<br />
16" (41cm) x 19" (48cm) x 10" (25cm)<br />
The fixture is tested and certified to:<br />
ASME A112.19.3-2008/CSA B45.4-08 standards.<br />
Installation:<br />
These fixtures are designed to be installed onto finished walls which are<br />
serviceable from a pipe chase. Installation is achieved by threading (6) 1/2”<br />
(13mm) diameter anchor rods to the back of the fixture. The anchor rods are<br />
then secured on the chase side of the wall with supplied hardware. (Standard<br />
included hardware is for walls up to 8" (20cm) thick).<br />
For existing walls, an optional metal cutout template is available. For new<br />
block (CMU) or poured concrete walls, an optional wall sleeve is available.<br />
Available Controls:<br />
The basin is controlled with an air-operated self closing valve with a non-hold<br />
open feature. Flow time is adjustable from approximately 5 to 60 seconds<br />
which has a flow rate of 2.2 gpm (8.3 lpm). The valve is operated by a vandal<br />
resistant push button which requires less than 5lbs to operate. The valve<br />
can be mounted up to 10 feet (3meters) away from the push button. Valve<br />
conforms to the requirements of ASME A112.18.1-2005/CSA B125.1-05.<br />
See basin valve options for available configurations.<br />
FIXTURE OVERVIEW:<br />
1 Sink Spout<br />
2 Push Button Actuator<br />
3 2 3/8" OD Plain End Waste<br />
4 Threaded Mounting Locations (x6)<br />
155<br />
GENERAL<br />
INFORMATION<br />
SINGLE COMPARTMENT<br />
DROP-IN SINKS<br />
CLASSROOM<br />
SINKS<br />
DOUBLE COMPARTMENT<br />
DROP-IN SINKS<br />
TRIPLE COMPARTMENT<br />
DROP-IN SINKS<br />
UNDERMOUNT<br />
SINKS<br />
VANITY<br />
BASINS<br />
DRAINBOARD<br />
SINKS<br />
SECURITYWARE
Change language