Untitled - Franke

Wash Basins & Trough Sinks Pedestal/Wall Hung Lavs
16" (41cm)
18 1/2" (47cm)
17 13/16"
[45cm]
11 5/8"
[29cm]
5 1/2"
[14cm]
19"
(48cm)
14"
(36cm)
13" [33cm]
15 3/4" [40cm]
18 1/2" (47cm)
10" (25cm)
7" (18cm)
40"
(102cm)
FWHB1819-3
SPECIFICATION:
18 gauge, type 302, 18-8 stainless steel. Polished satin finish. Radius
coved bowl corners. Base pedestal. One piece wall hanger.
1 1/2" (38mm) duplex waste assembly included, location center.
COMPARTMENT SIZE: 14" x 16" x 7" (36cm x 41cm x 18cm)
OVERALL SIZE: 19" x 18 1/2" (48cm x 47cm)
BACKSPLASH: 10" (25cm)
OVERALL HEIGHT: 40" (102cm)
FAUCET HOLE DRILLING OPTIONS:
This model is not returnable once drilled to your specification. Faucet
hole locations should be indicated relative to the sink orientation as
shown in the catalogue drawings. A sketch is recommended.
NOTES:
• Electronic specifications, reference www.kindred-commercial.com
WT400C-
SPECIFICATION:
Single compartment wall mount wash basin with faucet ledge.
19 gauge, 18-10 stainless steel. Exposed surfaces are brushed finish.
Includes installation kit. 1 1/4" (32mm) waste assembly, location
center back (not included).
COMPARTMENT SIZE: 11 5/8" x 13" x 5 1/2" (29cm x 33cm x
14cm)
OVERALL SIZE: 17 13/16" x 15 3/4" (45cm x 40cm)
WASTE OPTIONS:
-7 = Accepts 1 1/4" waste assembly
-8 = Accepts 1 1/4" waste assembly with integral rear overflow
Overflow No overflow Faucet hole drilling options
❑ WT400C-8/1 ❑ WT400C-7/1 1 hole, 1 1/2" diameter
❑ WT400C-8 ❑ WT400C-7 Custom (non-returnable)
*For custom please specify drilling requirements.
NOTES:
• Electronic specifications, reference www.kindred-commercial.com
• Optional shroud also available (refer to specification page WT-RS).
82 0311