Untitled - Franke

Securityware Products - Wash Basins & Sinks
20"
(50cm)
3"
(8cm)
12"
(30cm)
HDWSS202-FM-SV-LD shown
1
21" (53cm)
2
30"
(76cm)
10"
(25cm)
3 4
HDWSS2021-FM- -
Heavy Duty Wall Service Sink
Fixture Specification:
This Heavy Duty Wall Service Sink is designed for areas requiring the utmost
in vandal resistance. The fixture is fabricated from heavy 14 gauge type 304
18-10 stainless steel. It is seamlessly welded and polished to a satin finish.
Standard waste is a 2” Removable P-Trap.
Compartment Size: (FB x LR x D):
20" (51cm) x 21" (53cm) x 30" (76cm)
Bowl Size: (FB x LR x D):
16" (41cm) x 19" (48cm) x 10" (25cm)
The fixture is tested and certified to:
ASME A112.19.3-2008/CSA B45.4-08 standards.
Installation:
These fixtures are designed to be installed onto finished walls which are not
accessible from a pipe chase. Installation is achieved by means of a wall
hanger bracket and lower mounting holes. Mounting hardware and plumbing
are all self contained and only accessed by a removable panel. The panel is
secured with tamper resistant screws.
Available Controls:
The basin is controlled with an air-operated self closing valve with a non-hold
open feature. Flow time is adjustable from approximately 5 to 60 seconds
and has a flow rate of 2.2 gpm (8.3 lpm). The valve is operated by a vandal
resistant push button which requires less than 5lbs to operate. The valve
can be mounted up to 10 feet (3meters) away from the push button. Valve
conforms to the requirements of ASME A112.18.1-2005/CSA B125.1-05.
FIXTURE OVERVIEW:
1 Sink Spout
2 Push Button Actuator
3 2" Removable P-Trap
4
Removable Access Door (specify left or right)
154 0311