Fire Alarm Control Panels - Bosch Security Systems

40 en | System Operation Fire Alarm Control PanelsFor additional history log ID information, see the Modem IIIa 2 reporting table, 105.6.2.9Remote ProgrammingCall for remote programmingPhone Numbers 1 and 3 must be programmed, along with Account Code 1. The control panelcalls Phone Number 3 and attempts to connect for downloading. If the control panel is alreadyusing the phone line, it sounds the three-beep error tone. This function requires an accesscode with programming authority (Level 1).Answer for remote programmingThe control panel immediately seizes the phone line to answer a remote programming call.While programming is underway, the Trouble LED flashes. This also allows on-site PCdownloading. If the control panel already uses the phone line for a report communication, itsounds the three-beep error tone. This function requires an access code with programmingauthority (Level 1).6.36.3.1KeypadsBuilt-in keypadThe keypad built into the control/communicator is an alphanumeric LCD keypad. It has a twolineby 16-character display to provide information on various control panel functions. Usually,the first line shows the off-normal condition, while the second line describes specific detailsthat might be relevant to the existing system status. A built-in sounder annunciates keystrokeentries and acts as a warning device.2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.