Fire Alarm Control Panels - Bosch Security Systems

42 en | System Operation Fire Alarm Control Panels4 Yellow Silenced LED - lights when theuser manually silences an alarmcondition (fire or water flow), turns offwhen the condition that was silencedis corrected.5 [Disable] key - used to disable orre‐enable inputs, NACs or relays(outputs), and the dialer.6 [Test] key - used to select one of sevenspecial test modes. 17 [*/Back] key - used duringprogramming to exit from menus or toexit from the programming modeentirely.8 [0/Prog] key – for selecting theprogramming mode.12 [Silence] key - mutes the bell or sirensfor an alarm condition, if the system isso configured.13 [Drill] key – used to activate the NACsmanually. It creates a history log entryand as an option reports to the centralstation.14 Yellow Supervisory LED - lightswhenever the system registers asupervisory condition.15 Yellow GND Fault LED - lightswhenever the system detects a groundfault condition.16 [Acknowledge] key to silence localkeypad sounders and to step throughthe groups of off-normal conditions.1 For test modes, see Testing, 43.For abbreviations on the keypad and control panel, see Control Panel Display Descriptions,100.6.3.2FMR-7033 keypadThe FMR-7033 Keypad is an alphanumeric LCD keypad. Up to four of these keypads can bemounted apart from the main control panel to provide additional locations for system statusand control. The LCD display and keys operate identically to those of the built-in keypad onthe control panel.For operation, see Built-in Keypad callouts, 40.2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.