Fire Alarm Control Panels - Bosch Security Systems

58 en | Programming Fire Alarm Control Panelsinhibited (but alarm monitoring continuing), the system indicates SYSTEM TROUBLE,RMT PRG ACTIVE during remote programming. Sounders do not activate during this mode, butother outputs programmed for Zone 62, general system trouble, do activate.Trouble conditions that occur during a remote programming session are not annunciated atthe control panel until the remote programming session ends. These conditions are availablein the remote programmer diagnostic displays during the session. Alarm conditions terminateremote programming and are shown immediately.When remote programming is disabled, you can still connect to the control panel fordiagnostics and view the existing programming (except PIN numbers). To actually changeprogramming, enable remote programming.To enable remote programming, refer to the following programming items:– 0-3-7 Remote Programming, 67– 0-6-1 Computer PH/IP, 78– 0-6-1 Account Number 1, 78– 0-6-2 Dialing Type, 82– 0-6-4 Ring Count, 84– 0-6-6 Machine Bypass, 85An access code with maximum authority (1) is needed to begin remote programming from thepanel.2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.