Fire Alarm Control Panels - Bosch Security Systems

Fire Alarm Control Panels Control Panel Programming | en 73COPY FROMPOINT:_______Enter the point you wish to copy from and press [#/Enter]. COPY TO FIRST POINT:_______Enter the first point you wish to copy to and press [#/Enter]. COPY TO LAST POINT:_______Enter the last point you wish to copy to and press [#/Enter]. The PROG INPUTS menu appears.This feature does not copy the description. Point copy is intended for use only on inputpoints. Do not copy from an output point (future use), or copy over a programmed outputpoint. The copy operation automatically stops, with an error message, if outputs areencountered. While copying to a large number of points, the remote keypads might brieflyshow system fault, because the keypads are not updated during the copy operation.8.58.5.1PROG OUTPUTSPROG OUTPUTS1- NACs2- RELAYSProgramming NACsShortcut: 0-PROG, 5-PROG OUTPUTS, 1-NACsThe main control panel includes two local NACs (NAC 1 and NAC 2). The FPD‐7024 can alsosupport up to four FPP‐RNAC‐8A‐4C Remote NAC Power Supplies, which offers a total of 16remote NACs (four NACs per RNAC).The following window appears:NAC OUTPUTS1- LOCAL2- REMOTE 13- REMOTE 24- REMOTE 35- REMOTE 4Press the number key that corresponds to your selection.Local NACsShortcut: 0-PROG, 5-PROG OUTPUTS, 1-NACsThe display scrolls through the NAC options. Press [1] for LOCAL. The following windowappears:ONBOARD NAC1- NAC #12- NAC #2Press the number key that corresponds to your selection. The display scrolls through thefollowing selection:PROG NAC1- AUTO SILENCE2- CONFIGRATION3- ZONE ASSIGNSPress the number key that corresponds to your selection.If you select [2] from the PROG NACs menu, the following selections scroll:Bosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458