Fire Alarm Control Panels - Bosch Security Systems

More documents

Recommendations

Info

48 en | System Operation Fire Alarm Control PanelsiiNotice!To disable a phone number, set the FORMAT to 0=disable. To completely disable the communicator,set FORMAT to 0=disable for both phone numbers, and set MONITOR to 0=NO forboth phone lines.Notice!Do not install this control panel on a phone line that might be required for other emergencyuse.When events occur, the communicator sends them to the monitoring station in priority orderaccording to NFPA requirements. Fire and waterflow alarms are sent first, followed bysupervisory alarms and trouble reports and then all other reports. Priority reporting can senda Restoral report after several alarm reports in a situation where a point sends multiplealarms, implying that a point is restored when it has returned to alarm. The followingsequence, (alarm, restore, alarm) is sent as (alarm, alarm, restore) when priority sorting isapplied.!Warning!Event sorting can hide unrestored pointsPriority sorting on events sent to a monitoring station can cause the message sequence to implythat a point is restored when it is not.The communicator can store 32 events while waiting for the monitoring station to accept theevents. If more than 32 reportable events occur before the monitoring station accepts events,some event information is lost and a Data Lost report is sent to the central station.The FPD‐7024’s communicator is equipped with a line seizure relay to prevent interferencewith outgoing event reports. In a system where the fire communicator shares the phone linewith other equipment on the premises, the phone line might be unavailable to the otherequipment for up to 15 min has a fault with the central station acceptance of the event data.Phone lines for fire control panels must not be shared with other equipment.2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.
Fire Alarm Control Panels Programming | en 497ProgrammingDanger!Untested systems!After any programming change, and especially after remote programming changes, completelycheck the operation of the control panel. Hazards to life and property can result if the systemis not tested to detect possible improper programming.DANGER!!Warning!Improper system operation!When programming the system, enter only valid types of information within the ranges specifiedin the programming table. Incorrect programming results in improper system operation.When using built-in programming, invalid input values might not be rejected in every case. Ensurethat you enter only the intended values while programming to prevent improper systemoperation.7.1Programming featuresFor UL864 programming requirements, see the following table:Program feature oroptionPermitted in UL864(Yes/No)Possible settingsSettings permitted inUL864Auto Test Frequency Yes 4 HOURS12 HOURS24 HOURS7 DAYS28 DAYSProgram Relay Yes Release on TroubleActivate on GroundStartAC Fail Delay Yes Wait for DCWait Delay Time0‐24 HRS4 HOURS12 HOURS24 HOURSRelease on TroubleWait Delay Time1‐3 HRSPhone Line Monitorfor Each LineYesNoYesYesRemote Programming(offsite)Yes PHONE #1PHONE #2COMPTR PHONEPhone #1Phone #2Response Time Yes Fast (.5 sec)Programmed1 secBosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458
Page 6: MethodenberichtBerliner pairfam Stu
Page 14 and 15: 14 en | Overview Fire Alarm Control
Page 17 and 18: Fire Alarm Control Panels Overview
Page 19 and 20: Fire Alarm Control Panels Overview
Page 22 and 23: 22 en | Installation Fire Alarm Con
Page 30 and 31: 30 en | Connection Fire Alarm Contr
Page 36 and 37: 36 en | System Operation Fire Alarm
Page 50 and 51: 50 en | Programming Fire Alarm Cont
Page 60 and 61: 60 en | Control Panel Programming F
Page 98 and 99:
98 en | Specifications Fire Alarm C
Page 101 and 102:
Fire Alarm Control Panels Appendice
Page 103 and 104:
Page 105 and 106:
Page 107:
Page 110 and 111:
110 en | Appendices Fire Alarm Cont
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 122:
Bosch Security Systems, Inc.130 Per
show all

Fire Alarm Control Panels - Bosch Security Systems

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?