MOTOX gearbox - DS TECH

Technical description2.10 Surface treatment2.10.3 Primed versionTable 2- 3Primer according to corrosiveness categoriesPaint systemUnpainted (corrosiveness category C1 G)Cast iron parts immersion primed, steelparts primed or zinc-plated, aluminumand plastic parts untreatedPrimer according to corrosiveness category C2 G2-component metal primer, desired coatthickness 60 μmPrimer according to corrosiveness category C4 G2-component epoxide zinc phosphate,desired coat thickness 120 μmCan be overpainted withPlastic paint, synthetic resin paint, oil paint,2-component polyurethane paint,2-component epoxide paint2-component polyurethane paint,2-component epoxide paint and acid-hardening paint,2-component acrylic paint2-component polyurethane paint,2-component epoxide paint and acid-hardening paint,2-component acrylic paintOn gearbox or geared motor versions which are primed or unpainted the rating plate and themasking film are covered with a paint-protective film. These facilitate repainting withoutfurther preparation, e.g. masking with adhesive tape.Peeling off the paint-protective filmThe paint coat must have fully hardened before the paint-protective film is peeled off (be atleast "touch-proof").12345Company logoMasking filmRating platePaint-protective filmPeeling tabFigure 2-1 Rating plate with paint-protective filmProcedure1. Pull the peeling tab 5 up.2. Carefully peel the paint-protective film 4 off diagonally from one corner (not parallel tothe plate).3. Blow any paint fragments away or wipe them off with a clean cloth.You have now removed the paint-protective film.BA 201020 Operating Instructions, 05/2011