MOTOX gearbox - DS TECH

Installation4.10 Removing and installing the shaft-mounted gearbox4.10.2.2 Removing the hollow shaft with parallel keyCAUTIONBefore driving out the machine shaft, fasten a suitably dimensioned means of absorbingload to the gearbox.Slightly pretension the drive element so that the gearbox does not drop into the driveelement when the insert shaft is released.CAUTIONIt is essential to prevent misalignment when removing the unit.NoteIf frictional corrosion has occurred on the seat surfaces, use rust solvent to facilitate theremoval of the gearbox. Allow the rust solvent to work in sufficiently. 12345DiskThreaded blockParallel keyHexagon nutThreaded spindleFigure 4-9 Removing the hollow shaft with parallel keyItem 1 to 5 are not included in the scope of supply.Procedure1. Remove the axial fastening from the hollow shaft.2. Drive out the machine shaft using the disk 1, threaded block 2, parallel key 3,threaded spindle 5 and hexagon nuts 4.You have now removed the hollow shaft with parallel key.BA 2010Operating Instructions, 05/2011 41