MOTOX gearbox - DS TECH

Installation4.9 Removing and installing the protection coverProcedure1. Undo the screws 1 and remove the protection cover 2.2. Fit the output shaft.3. Using a suitable cleaning agent, clean the support surface of the protection cover 2 onthe gearbox.4. With the protection cover for shrink disk in the ATEX version, ensure that the O-ring 5 iscorrectly seated.5. Coat the supporting surface of the protection cover 2 with a suitable sealing agent.6. Screw on the protection cover 2.7. Protect all remaining bare areas with a suitable permanent anti-corrosive agent.You have now installed the protection cover for operation.BA 2010Operating Instructions, 05/2011 37