MOTOX gearbox - DS TECH

Installation4.5 Gearbox with foot mounting4.5 Gearbox with foot mountingCAUTIONDo not subject the gearbox to excessive stress when tightening the fastening bolts.The foundation must be level and free from dirt.The levelness deviation of the gearbox support must not exceed the following values:For gearboxes up to size 88: 0.1 mmFor gearboxes from size 108: 0.2 mmThe foundation should be designed in such a way that no resonance vibrations are createdand no vibrations are transmitted from adjacent foundations.The foundation structure on which the gearbox is to be mounted must be rigid. They must bedesigned according to the weight and torque, taking into account the forces acting on thegearbox. If the substructure is too weak, it will cause radial or axial displacement, whichcannot be measured at a standstill.When using foundation blocks to fasten the gearbox to concrete foundations, suitablerecesses should be made in the foundation.Align and grout the slide rails into the foundation.Align the gearbox carefully with the units on the input and output side. Take the elasticdeformation due to operating forces into account.Prevent displacement from external forces due to lateral impacts.Use stud bolts or headless screws of strength class 8.8 or higher for the foot mounting.Observe the tightening torque.BA 201030 Operating Instructions, 05/2011