ACS WebService Administrator Manual - Brivo Systems

Page 267Figure 155.View Enrollment ProgressQuality is based on how well the “ridge pattern” is defined (or how clear theimage is). Quality should be 40% or higher. To ensure a high Quality score,make sure the User’s finger is clean and the sensor is clear of dirt andresidue.Content is based on how much useful information is acquired from thefingerprint “core.” Content should be 20% or higher. To ensure a highContent score, make sure the finger is properly centered on the sensor.7. To accept the print, click Accept. To scan the finger again (or select a newfinger), click Reject and repeat the previous steps.8. After you have accepted a print, touch a smart card to the flat surface of thereader and hold it there for about a second. At this point, the user’s fingerprint“template” will be transferred to the smart card.9. You will receive a confirmation message after the fingerprint template issuccessfully written to the card. Click Close. You are returned to the Edit Userpage.10. Give the card to the user.11. If the card type is HID MIFARE 1431 (which includes proximity technology) andhas been added to the card bank — and the user requires access to doors withproximity readers — enter the card number in the Card # field on the Edit Userpage.12. When finished, click Save on the Edit User page.NOTE:The user’s fingerprint template resides on the smart card only and isneither saved to a central database nor to the computer serving asthe enrollment station. The system does, however, record whichfinger was enrolled (e.g. the “right index” finger) for administrativepurposes.