ACS WebService Administrator Manual - Brivo Systems

Page 283Speco DVR Installation NotesThe ACS WebService supports the following Speco DVR modelsDVR-4TN (all hard drive sizes)DVR-8TN (all hard drive sizes)DVR-16TN (all hard drive sizes)Speco TL or TH seriesSpeco TN SeriesSpeco CS/GS/LS/PS SeriesFirmware UpgradeThe DVR's firmware must be updated to version d2b02-66n1148E02581480. This firmwareversion is available through the Brivo support web site athttp://www.brivo.com/support/downloads.php. The following steps describe theprocess to upgrade the DVR’s firmware 11 :1. Burn the contents of the zip file downloaded from the Brivo web site onto ablank CD. When extracting the files, ensure that the “Use Folder Names” optionis enabled. Following the creation of the CD, verify that the only sub-folder inthe CD’s root directory is “upd200s”.2. Reboot the DVR.3. Enter the DVR menu using the front panel or remote control.4. Enter the DVR password and press . This action will cause the Mainmenu to be displayed.5. Select Option 10, “Shutdown”, on the Main menu. This action will cause theShutdown menu to be displayed.6. Select Option 2, “Reboot”, on the Shutdown menu. This action will cause theDVR to reboot.7. Following the restart of the DVR, place the CD created during Step 1 in theDVR's CD drive.8. Enter the DVR menu using the front panel or remote control.9. Select Option 1, System, from the Main menu. This action will cause the Systemmenu to be displayed.10. Selection Option 1, Version, from the System menu. This action will cause theVersion menu to be displayed.11. Select the “Upgrade Via Local Device” from the System menu. This action willcause the DVR to search the CD for a suitable firmware version to install. After afew minutes, a dialog will be displayed to confirm the installation of firmwareversion d2b02-66n1148E02581480.11This process requires physical access to the DVR.