Modeler

144LightWave 10 - ModelerThe Rounder Numeric WindowNOTE: The number of Rounding Polygonssetting will appear in the viewport.Inset distance as illustrated below:ActionsActivate Rounder — you must either select Activate or click on aModeler viewpoint before Rounder will actually round anyedges.Reset Rounder — select this to set all the controls on the panelback to their previous (ie. the last time Rounder was used)values.Points/EdgesSelect Points if you only want the points of your selected pointsto be rounded.Inset Presets. This is a popup list of preset inset distances (in theunits chosen in Modeler’s Options panel). You can choose whichlist of presets to use on the Presets Tab.Adjacent surfaces. This controls what surface is allocated to thenewly created rounding polygons. If this is selected then Rounderwill assign the surface to that of the original polygon adjacent tothe selected edge as illustrated below:Select Edges if you only want the edges defined by your selectedpoints or edges to be rounded.If it is unchecked, then a new surface is assigned to the newpolygons. The name of the new surface is given by the “NewSurface” control.NOTE: The central polygon on the point corner isadjacent to all the original polygons and hence itssurface allocation is intrinsically ambiguous — itis assigned the surface therounding algorithm first comes across.Number of rounding polygons — This option sets the number ofbevels that will be applied to the edge as illustrated below:New Surface. All newly created rounding polygons are assigned