Modeler

26Point SelectionLightWave 10 - ModelerTo add more points to a selection:Points generally appear in two ways on-screen, selected andunselected. Selected points are highlighted, while unselectedpoints remain small dots.To select points:Step 1: Use Point Selection mode (Point button or Ctrl+G).The Mode Selection buttons are located at the bottom-left of thescreen.Hold the Shift key while you select with your LMB to add points tothe existing selection or just click your MMB.To lasso a group of points:With the RMB, drag out a circle around points to select a group.As you might expect, you can add more points to a selectionby holding the Shift key and dragging out a circle around theadditional points you wish to select.To unselect points:If selected points exist (and you have released the mouse button),dragging over them with your LMB will unselect them. You canalso use the lasso by dragging with your RMB.Step 2: Drag your LMB over points in an object and then releasethe mouse button to select those points.To unselect all points:Click in any non-active (i.e., not a button) area on the toolbarto unselect all points. You can also use the Drop Current Toolcommand (/). Also, clicking on the number of selected pointsNOTE: Once you have selected points andreleased the mouse button, you cannot selectadditional points in the same manner.HINT: If you know the number of points you wantto select, check the information display above thePoint (Selection mode) button. It shows you thenumber of selected items.