Modeler

258LightWave 10 - Modelerare some adjustable parameters that will determine how the effectis applied. Dragging in the 3D view with your LMB paints thepoints under your mouse pointer.StrengthStrength sets the point from the center of the brush where thepaint falls off. If Strength is 100%, points inside the brush are allpainted with a the full Value. If Strength is 0%, the center of thebrush is painted with 100% of strength, and the value decreasesrelatively from from the center to the outer edge of the brush.If Strength is 50%, points within half the radius receive the fullValue, then it falls off toward the edge of the brush.The Brush Size and the Front settings are shared with the thevertex color painting operations.OperationSpecify how the point weight is applied:Strength = 100%. All the point inside the brush is painted with thesame value.ADD — This mode adds the Value to the painted target weight.Note that the operation is only applied once while you pressthe mouse button, start dragging, and then release thebutton.SUB — This mode subtracts the Value from the painted targetweight. Note that the operation is only applied once whileyou press the mouse button, start dragging, and then releasethe button.REP — This mode replaces the painted target weight with theValue.ERA — This mode sets the painted target weight to 0.0.Strength = 50%. Points inside half the radius are painted with100% of the Value, then decreases relative to the distance fromthe center.OVR — This mode replaces the weight only if the Value setting islarger than the painted target weight value.Value — This specifies the weight value that you are going topaint. A value of 100% is internally converted to 1.0 as aweight value. When you activate the picker button, you canrefer to the weight value in the 3D view. Dragging your LMBrefers to a weight value of the point that is closest to yourmouse pointer.Strength = 0%. The paint strength decreases relative to thedistance from the center of the brush.