1771-6.5.132, PLC-5 DeviceNet Scanner User Manual

More documents

Recommendations

Info

4-14 Configuring the DeviceNet Network3. Click on OK if you made any changes and close the Edit I/OParameters window for the RediSTATION.4. Click on OK again. You will be prompted to download the changesto the 1771-SDN module.5. Click on Yes to download the new configuration.AutoMapping the Devices into the ScanlistFollow the procedure below to automatically map the photoeye andRediSTATION to the PLC-5 processor.TIPIf you want to know how to map the devicesmanually, click on the Help button at the bottom ofthe screen and select “Map device input datamanually”.1. Double-click on the 1771-SDN module icon and select the Inputtab. You will see the following window.There are six available blocks.Block Xfer 62 is the default.2. Highlight the RediSTATION and the photoeye as shown above andclick on the AutoMap button.Publication 1771-6.5.132 - June 2000
Configuring the DeviceNet Network 4-15The resulting device mapping will appear in the lower panel of thewindow:File N9,Word 1Note: The source address is actuallydetermined by the block transferinstruction in the ladder logic. Seechapter 6.PhotoeyeinputsRediSTATIONinputsIn this example, the input byte from the RediSTATION will appearin the PLC-5 processor in file N9, word 1, as bits 0-7. Recall fromchapter 2 that the START button is bit 1 and the STOP button is bit0. Therefore, the addresses for the RediSTATION inputs are:START N9:1.1STOP N9:1.0The input byte from the photoeye will appear in the PLC-5processor in file N9, word 1, as bits 8-15. Recall from chapter 3 thatthe input bit is bit 0. Therefore, the address of the photoeye inputbit is:N9:1.83. Note the addresses assigned to the START and STOP buttonsand the photoeye in your system. You will enter these addressesin the example ladder program.Publication 1771-6.5.132 - June 2000
Page 1 and 2:
PLC-5 DeviceNetScanner Module1771-S
Page 3:
European Communities (EC)Directive
Page 6 and 7:
P-2 About This User ManualContentsT
Page 8 and 9:
P-4 About This User ManualCommon Te
Page 10 and 11:
P-6 About This User ManualTerminolo
Page 12 and 13:
P-8 About This User ManualPublicati
Page 14 and 15:
Table of ContentsiiConfiguring theD
Page 16 and 17: Table of ContentsivPublication 1771
Page 18 and 19: 1-2 Before You BeginWhat Your 1771-
Page 20 and 21: 1-4 Before You BeginThe 1771-SDN sc
Page 22 and 23: 1-6 Before You BeginCommunicating w
Page 24 and 25: 1-8 Before You BeginWhat 1771-SDN M
Page 26 and 27: 1-10 Before You BeginThe configurat
Page 28 and 29: 1-12 Before You BeginPublication 17
Page 30 and 31: 2-2 Planning Your Configuration and
Page 38 and 39: 2-10 Planning Your Configuration an
Page 40 and 41: 3-2 Hardware SetupInstalling the PL
Page 42 and 43: 3-4 Hardware SetupTo go online to t
Page 44 and 45: 3-6 Hardware Setup3. Insert the int
Page 46 and 47: 3-8 Hardware SetupSetting the Chann
Page 48 and 49: 3-10 Hardware SetupConnecting the S
Page 50 and 51: 3-12 Hardware SetupInstalling theSe
Page 52 and 53: 3-14 Hardware SetupPublication 1771
Page 54 and 55: 4-2 Configuring the DeviceNet Netwo
Page 62 and 63: 4-10 Configuring the DeviceNet Netw
Page 72 and 73: 5-2 Communicating with DeviceNet fr
Page 80 and 81: 5-10 Communicating with DeviceNet f
Page 96 and 97: 6-2 Creating and Running the Exampl
Page 104 and 105: 6-10 Creating and Running the Examp
Page 110 and 111: 7-2 TroubleshootingNetwork Status I
Page 112 and 113: 7-4 TroubleshootingNumericCodeDescr
Page 114 and 115: A-2 1785-ENET Module Channel Config
Page 116 and 117:
B-2 Installing and Configuring the
Page 118 and 119:
B-4 Installing and Configuring the
Page 120 and 121:
C-2 Installing and Configuring the
Page 122 and 123:
C-4 Installing and Configuring the
Page 124 and 125:
D-2 Data Map ExampleExample Framewo
Page 126 and 127:
D-4 Data Map ExampleIn 1-slot addre
Page 128 and 129:
D-6 Data Map ExampleExample OutputM
Page 130 and 131:
D-8 Data Map ExampleThe following i
Page 132 and 133:
D-10 Data Map ExamplePublication 17
Page 134 and 135:
2 Indexsetting the I/O chassis back
Page 136:
( )Other CommentsPLEASE FOLD HERENO
Page 139:
PLC-5 DeviceNet Scanner Module User
show all

1771-6.5.132, PLC-5 DeviceNet Scanner User Manual

Create successful ePaper yourself

Delete template?

Save as template?