1771-6.5.132, PLC-5 DeviceNet Scanner User Manual

More documents

Recommendations

Info

5-24 Communicating with DeviceNet from Another NetworkPublication 1771-6.5.132 - June 2000
Chapter 6Creating and Running the ExampleApplication ProgramWhat This Chapter ContainsThis chapter describes the procedure to create, download, and run anexample ladder logic program to test the DeviceNet network. Whenthe program is put into Run mode, pressing the START button on thenetwork’s RediSTATION will cause the red indicator light to come onand stay on until the STOP button is pressed. Passing an object infront of the photoeye will increment a counter.This chapter provides examples of downloading and running theprogram over ControlNet, Ethernet, and Data Highway Plus networks.You cannot directly communicate with the PLC-5 processor over theDeviceNet network.The 1771 I/O chassis used for these examples was set up with thefollowing hardware:Module Rack Group Slot IP AddressPLC-5/1785-ENET 0 0 0 130.130.130.21771-SDN 0 1 0 n/aThe following table describes what this chapter contains and where tofind specific information.For information aboutSee pageInstalling the Software 6-2Creating the Example Application Program 6-2Downloading and Running the Program 6-6Downloading and Running the Program via a ControlNet Network 6-6Downloading and Running the Program via an Ethernet Network 6-9Downloading and Running the Program via a DH+ Network 6-12MoreFor more information, see Getting Results With RSLogix 5, RockwellSoftware publication 9399-RL53GR.1 Publication 1771-6.5.132 - June 2000
Page 1 and 2:
PLC-5 DeviceNetScanner Module1771-S
Page 3:
European Communities (EC)Directive
Page 6 and 7:
P-2 About This User ManualContentsT
Page 8 and 9:
P-4 About This User ManualCommon Te
Page 10 and 11:
P-6 About This User ManualTerminolo
Page 12 and 13:
P-8 About This User ManualPublicati
Page 14 and 15:
Table of ContentsiiConfiguring theD
Page 16 and 17:
Table of ContentsivPublication 1771
Page 18 and 19:
1-2 Before You BeginWhat Your 1771-
Page 20 and 21:
1-4 Before You BeginThe 1771-SDN sc
Page 22 and 23:
1-6 Before You BeginCommunicating w
Page 24 and 25:
1-8 Before You BeginWhat 1771-SDN M
Page 26 and 27:
1-10 Before You BeginThe configurat
Page 28 and 29:
1-12 Before You BeginPublication 17
Page 30 and 31:
2-2 Planning Your Configuration and
Page 32 and 33:
Page 34 and 35:
Page 36 and 37:
Page 38 and 39:
2-10 Planning Your Configuration an
Page 40 and 41:
3-2 Hardware SetupInstalling the PL
Page 42 and 43:
3-4 Hardware SetupTo go online to t
Page 44 and 45: 3-6 Hardware Setup3. Insert the int
Page 46 and 47: 3-8 Hardware SetupSetting the Chann
Page 48 and 49: 3-10 Hardware SetupConnecting the S
Page 50 and 51: 3-12 Hardware SetupInstalling theSe
Page 52 and 53: 3-14 Hardware SetupPublication 1771
Page 54 and 55: 4-2 Configuring the DeviceNet Netwo
Page 62 and 63: 4-10 Configuring the DeviceNet Netw
Page 72 and 73: 5-2 Communicating with DeviceNet fr
Page 80 and 81: 5-10 Communicating with DeviceNet f
Page 96 and 97: 6-2 Creating and Running the Exampl
Page 104 and 105: 6-10 Creating and Running the Examp
Page 110 and 111: 7-2 TroubleshootingNetwork Status I
Page 112 and 113: 7-4 TroubleshootingNumericCodeDescr
Page 114 and 115: A-2 1785-ENET Module Channel Config
Page 116 and 117: B-2 Installing and Configuring the
Page 118 and 119: B-4 Installing and Configuring the
Page 120 and 121: C-2 Installing and Configuring the
Page 122 and 123: C-4 Installing and Configuring the
Page 124 and 125: D-2 Data Map ExampleExample Framewo
Page 126 and 127: D-4 Data Map ExampleIn 1-slot addre
Page 128 and 129: D-6 Data Map ExampleExample OutputM
Page 130 and 131: D-8 Data Map ExampleThe following i
Page 132 and 133: D-10 Data Map ExamplePublication 17
Page 134 and 135: 2 Indexsetting the I/O chassis back
Page 136: ( )Other CommentsPLEASE FOLD HERENO
Page 139: PLC-5 DeviceNet Scanner Module User
show all

1771-6.5.132, PLC-5 DeviceNet Scanner User Manual

Create successful ePaper yourself

Delete template?

Save as template?