user manual - Utax

Default Setting (System Menu)Use the procedure below to set the default EcoPrint setting.1 Press the System Menu key.2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ] twice, and then [Change] of EcoPrint.3 Select [Off] or [On] for the default.4 Press [OK].Toner SaveLevel(EcoPrint)Select the default Toner SaveLevel(EcoPrint). One of five levels [1] - [5] can be set.NOTE: Raising the level reduces toner consumption, but image quality falls.IMPORTANT: If you want to enable the changed defaults immediately, move to the function screen and pressthe Reset key.Use the procedure below to select the default Toner SaveLevel(EcoPrint).1 Press the System Menu key.2 Press [Common Settings], [ ], [Next] of Function Defaults, [ ] twice, and then [Change] of TonerSaveLevel(EcoPrint).3 Select from [1] to [5] for the default Toner SaveLevel(EcoPrint).4 Press [OK].9High Comp. PDF ImageSelect the default quality setting for high compressed PDF files.The table below shows the available settings.ItemCompression Ratio PriorityStandardQuality PriorityDescriptionCompression Ratio is given priority with smaller file size.Standard qualityImage quality is given priority with larger file size.Use the procedure below to select the default quality setting for high compression PDF files.1 Press the System Menu key.2 Press [Common Settings], [ ] and [Next] of Function Defaults. Press [ ] twice and [Change] of HighComp. PDF Image.3 Select the default for [Compression Ratio Priority], [Standard], or [Quality Priority].4 Press [OK].9-25