user manual - Utax

Preparation before UseHow to Load OriginalsIMPORTANT: Before loading originals, be sure that there are no originals left on the original eject table.Originals left on the original eject table may cause the new originals to jam.1 Adjust the original width guides.22 Place the originals. Put the side to be scanned (orthe first side of two-sided originals) face-up. Slidethe leading edge into the document processor asfar as it will go. The original placement indicator willbe lit.NOTE: For details on Original Orientation, refer toWhen placing originals on the document processor onpage 4-9.IMPORTANT: Confirm that the original width guidesexactly fit the originals. If there is a gap, readjust theoriginal width guides. The gap may cause the originalsto jam.Ensure that loaded originals do not exceed thelevel indicator. Exceeding the maximum level maycause the originals to jam (see the figure).Originals with punched holes or perforated linesshould be placed in such a way that the holes orperforations will be scanned last (not first).2-49