R 1200 CL

R 1200 CL
Alarm System Programming Information
Encoding Replacement RF Remote Controls
Note:To encode RF Remote Controls
you will need the 5 digit “personal pin
code” for the alarm system.The code is
entered into the system by synchronizing
the switching of the ignition key
when the appropriate LED flash corresponds
with each digit of the code.
A maximum of four RF remote controls
can be encoded on the system.
Activating the encoding function
1. Use a jumper to connect the programming
plug to battery
ground.
2.Turn the ignition switch to ON,
after a brief pause switch to OFF.
3. Wait for the first digit code to
flash ON and then OFF. Once
OFF, switch the key back ON.
4. Pause for approximately 5 seconds
and switch ignition off.
Repeat this process for each of
the remaining digits in the code.
5. On completion of the last digit,
three beeps will be heard indicating
encoding function is
active.
NOTE: If the beeps are not heard,
you must repeat steps 2 - 5 ensuring
the key is switched ON after the
last flash of the coded number
switches OFF.
Personal Pin Code Card
Signal the five digit code to the system by switching the ignition key ON when
the total number of flashes occur for each number in the code.
Example: Code input for 11559
124 R 1200 CL Introduction