R 1200 CL

R 1200 CL
PDI Procedures - Set Up
• Make sure the tool kit is complete.
Note the new unique R 1200 CL
tools included in the kit.
• Tire inflation shrader valve tool
• Ignition Coil removal tool
• 90 O bend phillips head screw
driver socket for removing rear
directional light lens covers.
• Radio Antenna wrench
• Install Antenna using special tool as
shown (from tool kit).
• Thoroughly wash motorcycle to
remove all transportation preservatives.
• Inspect the motorcycle thoroughly
for damage and or missing parts. If
necessary, submit a QEW (MTAS).
• If parts are needed, order them.
Part costs are reimbursed via a
warranty claim using defect codes:
Parts missing - 10 01 00 00 00
Parts damaged- 10 02 00 00 00
Parts Incorrect - 10 03 00 00 00
R 1200 CL Introduction
Make sure tool kit is complete
Install Antenna
• At this point you have completed the set up portion of the Pre Delivery
Inspection. Make sure an RO has been assigned to the PDI for the motorcycle
and convey any information about missing or damaged parts to the
parts department and warranty administrator.
• Perform balance of Pre-delivery inspection checks as outlined on the Predelivery
check sheet sample on the next page. PDI checklists are accessed
online from the MTAS (Aftersales> Service> Technical Information). As a
time saving tip, print out multiple copies and store them for future R
1200 C models.
49