R 1200 CL

R 1200 CL
PDI Procedures - Check Engine Oil Level
The engine is factory filled with oil and
only requires a visual check at the
sight glass. As long as oil level is visible,
it is ok for PDI test ride. However oil
level must be checked prior to customer
delivery as follows:
• Engine must be run to operating
temperatures and then allowed to
sit with engine off for 5 minutes
allowing oil to drain back to sump.
• With motorcycle in upright position,
level should be between Max/Min.
The difference between the marks
MAX and MIN is approx. 0.53 qt.
If necessary top off through filler.
Check Clutch Operating Fluid
• With motorcycle on center stand,
turn the handlebar fully to the right.
• Desired fluid level when clutch lining
is new is center of sight glass.
• If necessary, add DOT 4 brake fluid.
Note: Fluid level will increase as the
clutch plate wears. Fluid level must not
fall below minimum (center dot).
Check tire pressures
Tire pressures are same for all conditions
(solo, 2-up, & 2-up with luggage).
Front: 2.5 bar (36.25 psi)
Rear: 2.9 bar (42.05 psi)
Record your measured value on the
PDI sheet.
R 1200 CL Introduction
Checking Engine Oil Level
Checking Clutch Operating Fluid Level
Battery:
- Remove battery
- Add battery acid
- Allow battery to cool prior to charging
- Charge battery at 10% AH rating until fully charged
- Grease the terminal posts
- mark in service date
Integral ABS equipped - Perform bleed test with MoD
Check function of side stand safety function
Check headlamp (basic setting), adjust if necessary
36 42
Check torque setting of the rear wheel retaining bolts _
Check tire pressures - set at ______PSI front, ______PS
Check and adjust front and rear brake fluid levels
Check engine oil level, top up if necessary
f cessary
Record measured Tire Pressures
57