R 1200 CL

More documents

Recommendations

Info

$(Full p\340gina web.qxd)$

R 1200 CL BMW Inspection I Procedures (600 Miles) Check Vehicle History for outstanding Recalls using BMW DCSnet BMW inspections/services I, II, III, IV • www.bmwdcsnet.com/dcsnet Check Motronic and ABS fault memories with MoDiTeC BMW inspections/services I, II, III, IV • Connect MoDiTeC to diagnostic plug. • Read the fault memories of each system. Print out trace report and place into history file as proof completion. • If faults are logged, contact owner for approval. When advised, perform any diagnosis and repair work as necessary. Check Brake Fluid Levels and perform Integral ABS Bleed Test BMW inspections/services I, II, III, IV • Refer to procedure on page 54 of this manual. Check Tires BMW inspections/services I, II, III, IV • Check tire sidewalls and tread grooves • Check Tire Pressures. Tire pressures are same for all conditions (solo, 2-up, & 2-up with luggage). 68 Front: 2.5 bar (36.25 psi) Rear: 2.9 bar (42.05 psi) Check ABS sensors and pulse wheels for correct gap/contamination BMW inspections/services I, II, III, IV • Adjust and clean as required • Speed sensor gap 0.2-1.5mm Check Clutch Operating Fluid BMW inspections/services I, II, III, IV • With motorcycle on center stand, turn the handlebar fully to the right. • Desired fluid level when clutch lining is new is center of sight glass. Check Clutch Fluid Level • If necessary, add DOT 4 brake fluid. Note: Fluid level will increase as the clutch plate wears. Fluid level must not fall below minimum (center dot). If a large amount of fluid is needed to bring level up, consider the possibility of a leak in the hydraulic actuating system. R 1200 CL Introduction
R 1200 CL BMW Inspection I Procedures (600 Miles) Re-torque cylinder head Inspection I (600 Mi. only) • Remove ignition coils using new special tool 12 3 561 • Remove cylinder head covers. Caution: catch draining oil. • Do not remove spark plugs. • Set engine to OT (TDC) by turning the crankshaft with wrench or by placing in 3rd gear and rotating the rear wheel. • The OT will be visible in the inside window as shown • Loosen one cylinder head nut at a time. Loosen nut further by hand and oil threads with engine oil. • Retighten to: 20 Nm (14 ft. lb.) - Additionally, angle torque: 180 O. • Re-torque the remaining 3 cylinder head nuts in a crosswise pattern in the same manner. • Loosen and re-torque the M10 bolt: 40 Nm (29 FT. LB.) • Repeat on opposite side R 1200 CL Introduction 69
Page 1 and 2:
R 1200 CL • Technical Features in
Page 3 and 4:
R 1200 CL Table of Contents Subject
Page 5 and 6:
R 1200 CL Introduction Overview. As
Page 7 and 8:
R 1200 CL Engine The two piece ligh
Page 9 and 10:
R 1200 CL Clutch Centrifugal mass i
Page 11 and 12:
R 1200 CL Gear Box The engaging and
Page 13 and 14:
R 1200 CL Digital Motor Electronics
Page 15 and 16:
R 1200 CL Digital Motor Electronics
Page 17 and 18:
R 1200 CL Chassis and Wheels To pre
Page 19 and 20: R 1200 CL Chassis and Wheels The Mo
Page 21 and 22: R 1200 CL Chassis and Wheels The ne
Page 23 and 24: R 1200 CL Brake Components and Inte
Page 25 and 26: R 1200 CL Brake Components and Inte
Page 27 and 28: R 1200 CL Bodywork There are two wi
Page 29 and 30: R 1200 CL Bodywork Technical Featur
Page 31 and 32: R 1200 CL Headlights Lever Position
Page 33 and 34: R 1200 CL Electrical Components 3 1
Page 35 and 36: R 1200 CL 1. With the ignition in t
Page 37 and 38: R 1200 CL Cruise Control Technical
Page 39 and 40: R 1200 CL Sound and Communication S
Page 41 and 42: R 1200 CL Technical Data Clutch: Cl
Page 43 and 44: R 1200 CL Technical Data Dimensions
Page 45 and 46: R 1200 CL PDI Procedures - Uncratin
Page 47 and 48: R 1200 CL PDI Procedures - Uncratin
Page 49 and 50: R 1200 CL PDI Procedures - Set Up C
Page 51 and 52: R 1200 CL PDI Procedures - Set Up
Page 53 and 54: R 1200 CL PDI Procedures - Accessin
Page 55 and 56: R 1200 CL PDI Procedures - Removing
Page 57 and 58: R 1200 CL PDI Procedures - Checking
Page 59 and 60: R 1200 CL PDI Procedures - Check En
Page 61 and 62: R 1200 CL PDI Procedures - Check He
Page 63 and 64: R 1200 CL Retail Delivery Handover
Page 65 and 66: R 1200 CL Retail Delivery Check Lis
Page 67 and 68: R 1200 CL US Market Service Lubrica
Page 69: R 1200 CL Maintenance Schedule Chec
Page 73 and 74: R 1200 CL BMW Inspection I Procedur
Page 79 and 80: R 1200 CL Service & Maintenance Dat
Page 81 and 82: R 1200 CL New Special Tools - Part
Page 83 and 84: F 650 CS Additional Information New
Page 85 and 86: R 1200 CL Wiring & Terminal Designa
Page 87 and 88: R 1200 CL Power Distribution and Gr
Page 89 and 90: R 1200 CL Motronic M2.4 without Ant
Page 91 and 92: R 1200 CL Motronic M2.4 with or wit
Page 93 and 94: R 1200 CL Cruise Control 99/100 R 1
Page 95 and 96: R 1200 CL Instrumentation (Part 2 o
Page 97 and 98: R 1200 CL Horn, Hazard Flashers & T
Page 99 and 100: R 1200 CL Heated Grips/Seat & Diagn
Page 101 and 102: R 1200 CL Fuse Designations and Ele
Page 103 and 104: R 1200 CL Electrical Components Vie
Page 105 and 106: R 1200 CL Alarm System Programming
Page 107: R 1200 CL Alarm System Programming
show all

R 1200 CL

Create successful ePaper yourself

Delete template?

Save as template?