R 1200 CL

R 1200 CL
BMW Inspection I Procedures (600 Miles)
Check Vehicle History for outstanding
Recalls using BMW DCSnet
BMW inspections/services I, II, III, IV
• www.bmwdcsnet.com/dcsnet
Check Motronic and ABS fault
memories with MoDiTeC
BMW inspections/services I, II, III, IV
• Connect MoDiTeC to diagnostic
plug.
• Read the fault memories of each
system. Print out trace report and
place into history file as proof completion.
• If faults are logged, contact owner
for approval. When advised, perform
any diagnosis and repair work
as necessary.
Check Brake Fluid Levels and perform
Integral ABS Bleed Test
BMW inspections/services I, II, III, IV
• Refer to procedure on page 54 of
this manual.
Check Tires
BMW inspections/services I, II, III, IV
• Check tire sidewalls and tread
grooves
• Check Tire Pressures. Tire pressures
are same for all conditions
(solo, 2-up, & 2-up with luggage).
68
Front: 2.5 bar (36.25 psi)
Rear: 2.9 bar (42.05 psi)
Check ABS sensors and pulse
wheels for correct gap/contamination
BMW inspections/services I, II, III, IV
• Adjust and clean as required
• Speed sensor gap 0.2-1.5mm
Check Clutch Operating Fluid
BMW inspections/services I, II, III, IV
• With motorcycle on center stand,
turn the handlebar fully to the right.
• Desired fluid level when clutch lining
is new is center of sight glass.
Check Clutch Fluid Level
• If necessary, add DOT 4 brake fluid.
Note: Fluid level will increase as the
clutch plate wears. Fluid level must not
fall below minimum (center dot). If a
large amount of fluid is needed to
bring level up, consider the possibility
of a leak in the hydraulic actuating system.
R 1200 CL Introduction