R 1200 CL

R 1200 CL
PDI Procedures - Accessing Battery
• Remove both Left and Right side
painted trim covers (2) by removing
two screws (1).
• Remove fuel tank mounting bolts
and washers (1).
• Gently lift rear of tank and unplug
fuel pump connector (4)
• Disconnect two breather lines (3).
Note orientation and routing for
reinstallation.
• Release the quick disconnect fuel
lines (2) by pressing the release
catch (5) on each fitting.
• Handle the fuel tank gently to prevent
paint damage. Lift the fuel tank
at the rear and pull backward to
remove from forward mounts.
Note: The fuel system quick disconnect
fittings are sealed by an O’ring which can
be damaged if the fitting is not reinstalled
correctly.
Always inspect the seal for damage prior
to reconnecting this fitting. Always reset
the latch plates on the female half of each
union so the two halves can reconnect.
When reconnecting, gently slide the two
halves together squarely until an audible
click is heard. Always visually check the fitting
as well to ensure the union is sealed.
If the O’ring needs replacement order only
the O’ring which is available separately.
O’ring P/N = 13 31 7 659 110
52
Remove Left and Right side covers
5
Remove Front Seat
Remove Left and Right Intake Covers
R 1200 CL Introduction