R 1200 CL

R 1200 CL
PDI Procedures - Set Up
• The handlebars are lowered to
allow the motorcycle to fit into the
crate for shipping. HANDLEBARS
MUST BE ADJUSTED OR DAMAGE
TO THE FUEL CAP MAY RESULT.
• Loosen bar clamps on upper fork
bridge. Raise bars until dimpled
spot on bar is equal to mating surface
of bar clamp and fork bridge.
• Properly adjusted, bars should not
be closer than 3 - 5mm to fuel filler
door when open and bars full right.
Torque bolts to 19 Nm (14 ft/lbs).
• Hold mirror up to fairing mount
location. Connect directional light
connector (1) into wiring plug in fairing.
• Align ball socket unions and press
(snap) mirrors into place.
• Locate case in shipping carton and
prepare for installation. To remove
interior covering, unscrew case top
stop strap knurled screw anchor
(3). Use a small screwdriver and
press tabs (2) clear of stops and
remove covering (ie: K 1200 LT).
• Use shipping screws to install case
to four mounting base threaded
bores (1). The case mounts identically
to K 1200 LT model.
• Reinstall covering and reattach top
case stop strap and knurled screw
anchor.
48
Adjust Handlebars
Install Mirrors
Install Top Case
R 1200 CL Introduction