MacFinish 2D-USB Handleiding

MacFinish 2D-USB and MF8.x software Page 85
APPENDIX A: “Send Results“ Format
In the MacFinish program it is possible to send the result table via the same serial port which is used for
the scoreboard. This means that during the race we CAN send the running time trough this serial port
(depending on the scoreboard settings, see chapter 6.2) and after the race, when the result table contains
the Place+ID+Time results, we can send these results over the same serial port. You just have to select
“Send Result” from the document menu. Underneath the ‘Send Result’ protocol:
Format
Header+Data+Endofdata
Header= [SOH] @ [STX]
Data= [TAB] [CR]
[TAB] [TAB] [CR]
'n times for n participants’
Endofdata= [ETX]
Definitions: [SOH] = 01 Hex
[STX] = 02 Hex
[ETX] = 03 Hex
[TAB] = 09 Hex
[CR] = 13 Hex
@ = 40 Hex
= name of the document in ASCII
10_:_ {-}x.x _ = space
13_:_ {-}x.x
{} = optional
10*:_ {-}x.x
Man:_ {-}x.x
N/A N/A = not available
= 1 up to 225
= Lane number 1 up to 32
OR
= Athlete ID 1 up 99 999
< Time> = {M}{HH:}{MM:}{S}S.T{H} M = Manual Start Time
OR
“DNF” -Did Not Finish-
“DNS” -Did Not Start-
“DIS” -Disqualified”
“NR” -No Results-
EXAMPLE: (Note: The characters between brackets are ‘not printable’ characters)
100 m Boys Series 1[TAB]10 : -1.3[CR]
1[TAB]3[TAB]11.21[CR]
2[TAB]4[TAB]11.37[CR]
3[TAB]6[TAB]12.36[CR]